Maintenance and overhaul of the Austin Seven pt 1
From Practical Motorist, April 20 1940.

In fact there only appears to have been two articles published.

Valve cotters;  Removing the Cylinder Block;  Piston Clearance;  Pistion Rings:
Replacing the Block;  Main bearings;  Clutch attemtion;  Front Bearing


A7 Maint 1


A7 Maint 2

A7 Maint 3

 

See also:

Maintenance and Overhaul of the Austin 7 part 2
Engine bearings;  Gearbox;  Propeller shaft;   Fitting rubber joint cover:
Rea Axle;  Axle Leakage;  Renewing the Crown Wheel;
Re-assembling the Torque Tube;  Front Axle;  Steering Adjustments.   

Care and Maintenance of an Austin Seven  From The Motor, June 14 1927.


Other articles covering some of these topics can be found in Technical Articles - written by our members, and in Technical Advice - articles drawn from past motoring magazines.

 

Please note: The technical advice and information given in this article is that of the original author and the publication cited.  The Cornwall Austin Seven Club, its officers and members do not necessarily endorse the advice given in this article, and do not accept any liability for loss, damage or injury from persons acting upon that advice.  Anyone following the advice given in any of these articles, shall be deemed to have accepted this statement.

Our technical members are only able to answer questions relating to the Austin Seven (1922-1939) and may not be able to answer any questions arising from this article as they may have developed their own method of undertaking the work.

 

 

Back